Printer FriendlyEmail Article Link

During PLTS control plane, I am able to see the call go through, however, as soon as the Data Burst mesg is observed, I see that we get a "RF Lost Detected" and then the Call terminates.



When tests are run using Maximum Transmit Power condition, this can causes clippings in the reverse link signal and results in message errors. Retransmission at protocol level usually corrects them. However, there would be noticeable error messages in AirAccess. In some cases this can even cause dropped calls.

                There is a parameter in the mobile that can correct this situation. It is the Reverse Link Attenuation Offset parameter. The typical value would be to set this to -60. For greater details go to paragraph of the PLTS Reference manual.