Customer Service Center

Answer   1. Turn off the 3rd SR3452.   2. Connect a serial cable to the 3rd SR3452 Aux 2 port.   3. On a PC, open up HyperTerminal and set baud rate to 115200, and flow control to “None”.   4. Turn on the SR3452, you will see from the HyperTerminal scree that it is booting up.   5. Type in any key to change the boot parameter.   6. Change the boot parameter associated with the IP address to 192.168.0.27, leaving everything else the same.   7. Type in @ to continue boot or Power Cycle the SR3452 until it is fully up.