Customer Service Center
Home
Knowledge Base
Contact Support
License Activation
|
Contact Support
|
License Activation
|
Spirent KB Article
Doc ID: FAQ13781
Printer Friendly
Email Article Link
Spirent TestCenter: How to set DRV to only use the Drop count from the expected Rx port instead of all the other ports that receiving the same stream ID?
Environment/Versions
Spirent TestCenter
Dynamic Results View - DRV
v4.24
Answer
Use analyzer preload and add filter IsExpected > 0 in the DRV to remove flooded streams.
If you see unexpected streams show up as “Is Expected”, delete all analyzer streams if you had streams on analyzer before you enabled the preload.
One method to delete all analyzer streams is to first set "Delete inactive stream from memory". This can be found in Settings under the Traffic tab.
Next inactivate all streams and click apply.
Then set the Analyzer preload option if not already checked, then activate all streams and click apply.
Note that "Is Expected" column only works with Analyzer Preload.
If Analyzer Preload is not enabled, the "Is Expected" column will always show a value of "1"
There is a CR: 518517362 open to allow Analyzer Preload to be supported with Q-in-Q devices.
So currently if you have a configuration with Q-in-Q devices, the "Is Expected" column will not work since Analyzer Preload is not supported.
Work around is to use the Port Stray Frames column.
This can be enabled in Settings->L2L3 Results->Collect Stray Frames
Then in the DRV go to Streamblocks->Basic Counters
Version
2.0
Publish Date
2014-04-15
Categories
Product : Spirent TestCenter
Related Articles