Customer Service Center

• PosApp (SimGEN / SimREPLAYplus / SimGEN)
• GSS6560
• GSS6700

The basic answer is "Yes". But the following things need to be considered:-

1. A GSS6700 can work with all PosApp modes but a GSS6560 is only used with SimGEN mode
       - SimGEN can load 'SimGEN' (.scn) and 'Replay' (.scn_replay) scenarios
       - SimREPLAYplus and SimREPLAY can only load .scn_replay scenarios
       - SimGEN can be used to save scenarios in both .scn and .scn_replay formats
       - A SimREPLAYplus can only be used to save scenarios in the .scn_replay format
       - You need SimGEN v2-83 or later to create .scn_replay scenarios
    
2. It really only makes practical sense to use SimGEN to create scenarios
       - SimGEN has full scenario development capability
       - It is not practical to use SimREPLAYplus to make .scn_replay scenarios for a SimGEN system
    
3. You can only create scenarios with signals types that match the simulator signal capability
       - The GSS6700 can support GPS / GLONASS / Galileo / QZSS / BeiDou
       - The GSS6560 is GPS only
       - For example, a GSS6560 can't be used to create a GPS+GLO scenario
    
4. Scenarios from very different software versions may be incompatible
       - Systems that share scenarios should be kept at the same software version (and firmware and FPGA where possible)
       - Scenarios created with a new system configuration may not run with an old configuration
       - Scenarios created with an old configuration should always work with a new configuration