Customer Service Center

  Dual box

• GSS6700
• GSS6300M
• GSS6300

Of course regardless of mode you should get the same power. If power levels are different one of the following is possible:

1. The user equipment is connected to the output of the wrong unit
   • In single box mode there is no choice of where to connect your device under test (DUT)
   • However in dual box mode there are two outputs; only 1 of them has all of the GNSS signals present and at the correct levels
     • Connect your DUT to the unit that has the AUX I/p present on the rear panel
2. A  hardware error
   • Check the cable that connects the MON/CAL port to the AUX i/p is connected properly, also check for signs of damage
3. A configuration error is present most likely in the sig_gen.txt file
   • send the file to support@spirent.com along with a problem description and the steps taken so far