Customer Service Center
Home
Knowledge Base
Contact Support
License Activation
|
Contact Support
|
License Activation
|
Spirent KB Article
Doc ID: DOC11216
Printer Friendly
Email Article Link
Spirent TestCenter Release Notes (4.86)
Summary
This release notes document is for the latest Spirent TestCenter software base packages, test packages, and hardware. Click the attached PDF to open the release notes.
The following is a partial list of new content that is being introduced as part of this release.
Hardware Features
DX3-400GQ-P2 2-port CFP8 Test Module
Support for 200GbE and 100GbE on Spirent TestCenter
PX3-400GQ-P2 2-port CFP8 Test Module
Support for 400GbE and 200GbE on Spirent TestCenter
DX3-400GQ-T2 2-port QSFP-DD Test Module
Support for 200 GbE and 100GbE on Spirent TestCenter
PX3-400GQ-T2 2-port QSFP-DD Test Module
Support for 200GbE on Spirent TestCenter
(Note: Please refer to the
New Features
document for the new supported speeds on other variants of the test modules listed above.)
PX3-100GQ-T12, 12-port QSFP28 Test Module
Phase B supports 40GbE and 10GbE on Spirent TestCenter
Spirent TestCenter MX2-11AC-WAVE2-2N Test Module for N11U and N4U Chassis
MX2 802.11 AC WAVE-2 2-PORTS 2.4GHz and 5GHZ, DFS Radar Signal Emulation and Testing, and Hardware Timing
Software Features
PX3-100GQ-T12, 12-Port QSFP28 Test Module
Phase B now supports RIT of 64K in the Route Insertion Table (RIT).
Staggered Start and Stop
On FX2/MX2 10G and 1G test modules, staggered start now supports 500ns
EVPN E-Tree Extended Community and PMSI Tunnel Attributes
Supports configuring E-Tree Extended Community for both EVPN type-1 per ESI auto-discovery routes and type-2 MAC advertisement routes.
Supports configuring PMSI tunnel attributes and enabling composite tunnel bits in the EVPN type-3 routes.
EVPN MPLS Wizard
Supports BGP segment routing (BGP-SR) as one of MPLS transport options for EVPN in the EVPN MPLS wizard.
Supports encoding part of the EVI value (2 or 3 bytes) in MAC addresses at a configured offset for emulated VM hosts behind PE in the provider router EVPN type 2 routes, and for customer side host devices
Supports incremental steps for MAC and IPv4/IPv6 addresses for both emulated PE host devices and customer side devices per Ethernet tag / attachment circuit.
MAC Mobility Wizard now supports defining a fixed or random time delay between two consecutive moves for emulated VMs in the MAC mobility wizard
Access Traffic Realism Control and Data Plane Mode for PPPoE IPv6 (MX3/MX2/FX3/FX2)
Segment Routing supports two Node Descriptors Sub-TLVs defined in BGP-LS SR EPE draft and three BGP-LS link attributes TLVs defined in the EPE draft
RSVP-TE wizard supports configuring DUT System ID for ISIS
Ability to send IPv4 or VPNv4 routes with IPv6 as Next-hop in the NLRI update (RFC 5549)
TSN
Mixed Traffic Use Case added to Preemption (802.1Qbu) Wizard
New IEEE 802.1Qci (Per Stream Filtering and Policing) Wizard
Spirent TestCenter WLAN platforms including C1 and C50 appliances and test modules can now be configured to perform WLAN Access Point (AP) emulation for WLAN device testing
Spirent Telemetry (Analytics) Service is now enabled by default on Spirent LabServer
Attachments
Attachment
Spirent TestCenter Software and Hardware Release Notes_4.86.pdf
Attachment Description
Spirent TestCenter Release Notes (4.86)
Version
6.0
Publish Date
2019-11-07
Categories
Product : Spirent TestCenter,Spirent TestCenter
Related Articles