Customer Service Center

Environment/Versions Spirent TestCenter BGP Default route Answer Open Spirent TestCenter Application, connect to a chassis, and reserve the ports you will use. Configure, at least 2 emulated devices, one at each port. Set the devices, IP and BPG, configuration to match with your testbed. On Spirent TestCenter Application, go to the device on which you will configure de default route, open the BGP tab, and hit the Edit Routes… button. Add a new route using the values below: Start Network: 0.0.0.0 End Network: 0.0.0.0 Prefix Length: 0 Use Device Address as Next Hop: Disabled Next Hop: The IP address of the device configured on the other Spirent TestCenter port. Go to Traffic Generator option under that same port, and add a Raw Stream Block.   Under the Frame tab, configure the following: Destination MAC: DUT inbound interface MAC address. Destination: Any valid IP address. Gateway: DUT inbound interface IP address. Start BGP on the Spirent TestCenter emulated devices and wait until the session gets established. Start the traffic on Spirent TestCenter Application.  Attachments Attachment Sample Default BGP route.tcc