Customer Service Center
Spirent KB Article
Doc ID: FAQ19364
Email Article Link
STC: How to create a B2B Multicast VxLAN configuration on Spirent TestCenter Application
Spirent TestCenter Application.
Open Spirent TestCenter Application, connect to a chassis, and reserve 2 ports. (The ports must be connected Back-to-Back).
On the top menu, go to
Wizards > Wizards…
textbox and select the
option under Switching.
Configure VXLAN Ports
select both ports.
Set the IP addresses and gateways as in a Back-to-Back scenario.
Configure Learning Mode
; you can choose between
You can leave the values in the other screens as they are.
Configure Non-VXLAN Port
screen, Un-check the Use Non-VXLAN Ports, and hit the Finish button.
Go to the
All Stream Blocks
at the lef menu, and hit the
Enable both ports, and create a
stream from the VM emulated device under port 1 to the VM emulated devices under port 2.
Don’t forget to click the
button to confirm the Stream.
You can leave the default values on the other screens.
Apply the configuration in the Spirent TestCenter Application, and start the devices.
Go to the
tab, and wait until the VTEP state changes to
Right-click on any VTEP device and go to
VXLAN > Show VXLAN Bindings
If the configuration is correct, you will see:
The number of how many Bindings have STC learned and the number of VM MAC addresses resolved.
All the bindings states as Resolved.
Please consider that you need to do this for both ports.
ss VXLAN_B2B_Multicast Rev A.tcc
Product : Spirent TestCenter,Multicast,VXLAN