Customer Service Center

This release notes document is for the latest Spirent TestCenter software base packages, test packages, and hardware. Click the attached PDF to open the release notes.
The following is a partial list of new content that is being introduced as part of this release.
The New Features document includes detailed descriptions of each new feature and many helpful GUI screen captures. 

                   Hardware release – 800G

• Spirent B2 800G 4-Port QSFP-DD800 Appliance  (B2-800-QD-4-T1S)​
  • Add 1x800G full support​
  • Add 4x200G, 2x200G and 8x50G speeds​
• ​Spirent B2 800G 4-Port OSFP Appliance  (B2-800-OSFP-4-T1S)​
  • Available in both 4-port and 2-port variants​
  • Support 1x800G, 2x400G, 4x200G, 2x200G, 8x100G, and 8x50G speeds

• BGP FlowSpec Support on Dual Stack BGP Device​
• BGP FlowSpec Support Redirect Traffic to SRv6 Policy​
• BGP Segment Routing Policy draft update (version 14)​
• BGP SRv6 Traffic Binding Support SID Edition​
• BGP Segment Routing Policy Support Reverse Binding SID​
• BGP Segment Routing Policy: Add 7 modifiers for Key Attributes​
• ​SRv6 VPN Wizard: Added SID List Step and Outer IPv6 Destination Step​
• ​TWAMP:  Allow Same Destination UDP Port on Multiple TWAMP Sessions​
• ORAN Enhancements​
  • Support Resource Block Identifier​
  • Support Selective RE Sending Compression​
  • Support Configurable Section ID​
• RoCEv2 Enhancements​
  • Support RoCEv2 DCQCN Profile configurations​

• Enable sequence generation and split scenario, recovery and elimination on End system / Relay system​
• Supported hardware:​
  • PRP TX is supported in all hardware types. ​
  • PRP RX Analysis is supported in 1G speed on Spirent FX2-1G-Sx, MX2-1G-Sx, and NIC-65 In STC_ADV TSN Mode