Customer Service Center
Spirent KB Article
Doc ID: FAQ18728
Email Article Link
Spirent TestCenter: How to configure FCoE on STC using two B2B ports?
Open the GUI and connect to your chassis.
Create 4 devices, 2 on each port. The devices you're going to create may have checked the
option for the
It's recommended to name the devices as
or something that will help you to identify them.
to the encapsulation of every device. To do this, click on any of the cells under the
column and then on the square with the ellipsis.
World Wide Port Name
so that each device has a different value.
both of the devices that will work as
. You will find this option under the
value in one of the devices, so that it won't match the value on the other device.
both of the
devices. You will find this option under the
value in one of the devices. The
VN_Port FC Map
should match with the
VF_Port FC Map
After that, on the
tab, highlight the VF devices, right-click over one of them, and go to
FCoE VF_Port > Start FCoE VF_Port
After that, the
Aggregate Sub State
will go into
this means that you have
Once you have configured this, you can create your stream blocks and run traffic. It's important to mention that the stream blocks need to be configured between the
Product : Spirent TestCenter,FCoE